Pipe cold bending. Flexure depth with the main shaft.

Calculates the section flexure depth with pipe bender or bending machine to obtain given parameters.

This article was written by users' request to calculate the section flexure depth with the main shaft to obtain the bent pipe with given parameters.
Before the request, I didn't know that cold bending machines exist. Besides, there are industrial bending machines and manual hydraulic benders.
They are working the way you can see in the picture.
.

tube_bending_machine.jpg

Section (pipe) is placed between the rollers, then the main roller bends the section, and the remaining part slides through the bending machine.
From my amateur point of view, this process looks like this

  1. Placing the section

    drawing1.png

  2. Bending it
    drawing2.png

or, if we combine

drawing3.png

So, the question is, how hard we should bend the tube, i.e., lower the main shaft that after sliding the section through, would we have the needed curve? The curve is set with a radius. But as the user's request showed, parameters can be set not by the radius only but by the length and height of a chord if you need an arc. The calculator that calculates the length of a section (L) and circle radius (R) by the given length (C) and chord height (h) - see the picture.

1304848895.png

PLANETCALC, Segment defined by chord and height

Segment defined by chord and height

Digits after the decimal point: 2
Radius
 
Area
 
Arc length
 
Angle (degrees)
 
Perimeter
 



More info and formulas here- Circular segment

Let's move on.
If we need to have a flexure depth knowing the radius, distance between driven rollers, rollers radius, and section size.
Let's rewrite the combined picture, adding a few necessary lines and removing all unnecessary.

drawing4.png

Point B is the center of our circle. Notice that the outer edge calculates the profile relative to the curve. Since the radius of the height and width of the chord is likely to be calculated according to the profile's axis, the radius of the profile should be added to the obtained radius so you will have the radius of the outer edge of the profile.

Then the geometry is used.
From the distance AC and AB we find ABD triangle
\alpha=arcsin \frac{\frac{AC}{2}}{AB}

Hence
IB = AB cos \alpha
EB = DB - IB + AG

And here is the calculator

PLANETCALC, Pipe cold bending. Flexure depth with main shaft.

Pipe cold bending. Flexure depth with main shaft.

Radius at the outer edge of the section
Distance between the axes of the driven rollers
Driven roller radius
Digits after the decimal point: 3
Flexure depth
 

URL zum Clipboard kopiert
PLANETCALC, Pipe cold bending. Flexure depth with the main shaft.

Kommentare